How to improve the safety factor of advertising doors?

How to improve the safety factor of advertising doors?



How to improve the safety factor of advertising doors? The safety problems of advertising gates in use cannot be ignored, because these automatic devices will inevitably have some failures, so more or less there will be some safety problems. So how to improve the safety factor of advertising doors? Next, let Bian Xiao of Shenzhen Yongpengsheng advertising door manufacturer explain it to you in detail. Details are as follows:



1、 Key points to improve the safety factor of advertising doors:



1. Enhance the anti-collision function of advertising doors. During the planning and installation of advertising doors, speed reduction devices, such as speed bumps, need to be set at the entrance and exit to prevent the entrance and exit vehicles from traveling too fast and damaging the door posts.



2. It is very important to improve the anti-collision ability of the advertising channel itself. For example, through the ground induction trigger, if the door lever receives the ground induction input trigger during the lowering process, the door lever will immediately rise to the straight line state. During the triggering process, the door lever will not retreat to prevent being hit during the lowering process.



3. When planning advertising doors and installing parking systems at the entrance and exit of the parking lot, the needs should be selected according to the site environment. For example, some car owners can't control their speed well when going uphill and downhill, so they simply hit the doorpost. Therefore, users need to select parking lot systems with different access modes according to the site environment.



2、 In order to improve the safety factor of advertising doors, you should know the following safety knowledge:



1. When the brake lever of the advertising road brake falls, stop placing objects under the brake lever or someone is standing.



2. When the advertising door is powered off, turn off the power first, and then shake it manually until the brake lever is in a straight position.



3. When the gate of the advertising door is running, it is forbidden for the staff to open the box cover and door to avoid personal accidents.



4. Before the gate of the advertising door leaves the factory, the wires shall be laid in the box. If it is not a special case, the user cannot change it, and only needs to connect 220V power supply to work.