How to improve the safety factor of advertising gate?

How to improve the safety factor of advertising gate?



How to improve the safety factor of advertising gate? The safety of the advertising gate in the use process can not be ignored, because these automatic equipment will inevitably have some failures, so more or less there will be some safety problems, so how should we improve the safety factor of the advertising gate? Next, let the small editor of Shenzhen Yongpengsheng advertising barrier manufacturer explain it in detail. The contents are as follows:



1、 Key points to improve the safety factor of advertising doors:



1. Improve the anti-collision function of advertising doors. During the design and installation of the advertising door, it is necessary to set up speed reduction devices at the entrance and exit, such as speed bumps, to prevent damage to the barrier bar due to excessive vehicle speed. Inlet and outlet.



2. It is very important to improve the anti-collision ability of the grid bar itself. Taking the ground sensor trigger as an example, if the gate pole receives the ground sensor input trigger during the descending process, the gate pole will immediately rise to a straight state, and the gate pole will not retreat during the triggering process to prevent being hit during the descending process.



3. When planning advertising doors at the entrance and exit of the parking lot and installing the parking lot system, it needs to be selected according to the site environment. For example, some car owners can't handle the speed well when going uphill and downhill, and they simply hit the brake lever. Therefore, it is necessary for users to select parking systems with different access modes according to the site environment.



2. In order to improve the safety factor of the gate in the advertising lane, the following safety knowledge should be understood:



1. When the brake rod of the advertising roadblock falls, it is prohibited to place objects or people standing under the brake rod.



2. When the advertising door is powered off, turn off the power first, and then shake and swing with your hand until the brake lever is in a straight position.



3. When the advertising gate is running, it is forbidden for the staff to open the box cover and door to avoid personal accidents.



4. Before leaving the factory, the advertising gate shall be laid with wires in the box. If it is not under special circumstances, the user cannot change it, just connect the 220V power supply.



Qingdao Road gate installation, Qingdao Road gate manufacturer